Curtain Style / January 29, 2019 / Aaliyah Dotson.
An end-stop should be placed at both ends of the curtain tracking setup. Curtain tracking end-stops are used to prevent curtain carriers from slipping out. One end should contain a snap out fitting to allow for easy installation and replacement of curtain carriers. Snap out fittings sit inside an end-stop and are easily removed. Removal is necessary to install or replace your curtain carriers without removing the curtain tracking from the ceiling.
As a screw is inserted into the anchor; the anchor expands and grabs firmly to the ceiling. Drop downfalse ceilings require clips which are attached to the ceiling grid. There is a hole tapped into each clip that accepts a screw from the curtain tracking. These clips should be placed every 30".
Quality curtain tracking is made of 16 gauge extruded aluminum and is typically sold in eight foot lengths. If shorter lengths are required, tracking may be easily cut down with a hacksaw. Curves pre-bent to 45 deg. and 90 deg. are available for applications requiring the curtain to bend around a room; curves are 2 feet by 2 feet and bent at a 12 inch radius.
Once you have determined what length of curtains you would like you need to then measure the length with a tape measure curtains are usually manufactured or made in pairs but the measurements you see on ready made curtains on the packaging is individual curtain measurements rather than both of them together generally the total width of both curtains should be 2 to 2 times the width of the curtain pole or the track. This is only a rough guide and if you have any other questions please get in touch with us here at curtains online.
You MightAlso Like